Evangelina Horn Flooring November 17th, 2018 - 01:43:10
The installation takes a few days so plan. Accordingly, in some cases, you can install over old vinyl flooring, but it's best to get down to your sub floor to remove vinyl, cut it into small pieces and pull it up from the sub floor. A scraper and adhesive remover can be helpful to remove the vinyl glue. Your sub floor must be in good condition of proper thickness, uniform and level clean and dry for wood sub floors make sure the panels are securely attached to the floor.
Joists to verify the thickness of wood floors, check a floor register or drill a small hole and note the bit depth 5/8 inch. Plywood should be sufficient for floor joists spaced every 16 inches, add another layer of OSB or ply if your sub floor isn't thick enough. Next, make sure it's uniform a flat. The sub floor is extremely important to keep plank tiles from cracking use. The leveling compound on low spots or sand high spots finally make sure your subfloor is dry and clean with the sub floor prepped you can install the substrate.
The two options are cement backer board or a thinner, waterproof, uncoupling membrane, which is ideal for kitchens. Before you install the substrate prep the door, jambs stack a floor tile on a piece of the substrate against the trim, use a saw to cut it about 1/16 inch. Above the tile and cut doors 1/8 inch above the tile, we're using the uncoupling membrane roll it across the floor and cut it to length accounting for a quarter inch perimeter expansion gap set it aside and spread are cement mortar with the flat side of the Trowel then comb over it in straight lines, place the underpayment on top and use a float to press it into the mortar, continue installing across the room, cutting the underpayment to fit where needed, mark floor registers, so you can cut them later.
Waterproofing, the seams is a good idea in the kitchen spread unmodified thin-set across the seams and press the waterproofing band over top be sure to cut out any floor registers allow the thin-set to cure following the manufacturer's instructions. Then you can mark your starting line mark the center of two opposing walls or cabinets and snap. A chalk line on the floor.